Main Page Sitemap

Honeywell security keypad manual 6160


Features, supports wireless key transmitters (e.g.; 5804) and bi-directional transmitters (e.g.; 5804BD, 5828/5828V).
Follow these steps to mount and wire the keypad:.The 6160RF can be surface mounted directly to walls, or to a single- or double-gang electrical box.Set keypad-related data fields: *21 Quick Arm Enable, *23 Forced Bypass, and *84 Auto Stay Arm.Refer to Figure 1 for location of the case back release snaps and locking tabs.Armed, ready, nOTE: TO remove rear cover, pUSH IN THE TWO mounting.The 6160 keypad has a 32 character display screen which features English status messages.16 large telephone-style backlit keys located behind a decorative door that swings down to provide access to the keys.Repeat for the other side.Release, snaps, figure.Use data fields to enable keypad addresses, manual de proyector sony vpl-es2 assign a partition, and enable sound options.Place the appropriate label in the indented area on each key, so that the user can easily identify each key's function.Both the screen and the keys are backlit.(Red ready, lights when the system is ready to be armed (no zone faults are present).Replace the transmitter if the wireless transmitter does not have a replaceable battery.
Refer to the control panel's programming guide for the complete list of programming commands and explanations.
The table describes the error messages and the corrective actions.
Figure 2 - 6160RF Wiring Details K0903V1 2/06 Rev.
Home, about, contact, user Manuals, Guides and Specifications for your Honeywell ademco 6160 Keypad.
Once installed, to enable the 6160 keypad, start by setting the address at the keypad.Database contains 1 Honeywell ademco 6160 Manuals (available for free online viewing or downloading in PDF Installation and setup manual).B tones for successful panic KEY pair 6160RF-001-V1.If desired, wires may be strain-relieved to the wire tie point on the inside of the case back with a tie wrap (not supplied).(Check the User Guide that accompanies the control panel for detailed instructions on the use of these keys.).To enter programming, enter the installer code (Honeywell's factory default installer code is 4112) followed by the numbers 800.Provides a nominal range of 200 feet' for RF transmitters (some transmitters have a shorter range).Removing the keypad's case back provides access to the terminal blocks.The main keypad address should be addressed.Use data field *57 to program the 4 function keys on the right hand side known as A, B, C and.The large chevy bowtie patch panic alarms are activated by pressing key pairs 1 3 or * or a Special Function Key.


Sitemap